Description

Heating cable made up of a very fine metallic resistance which is provided with double insulation and covered with a very elastic silicone sheath. Its particular characteristics allow Aquacalor to be used both in the substrate and in the irrigation tank.

It is easy to use where you just have to plug it into the electrical network (Voltage 220-240V/50Hz) and that's it, it will automatically regulate the temperature.

Features

• Made with extremely fine metal resistance.
• It has high security standards.
• Preserves the heat of the water.
• Voltage 220-240V/50Hz.
• Aquacalor 15W – Length: 400cm
• Aquacalor 25W – Length: 500cm
• Aquacalor 50W – Length: 700cm

INSTALLATION

• Fix the suction cups to the bottom of the aquarium by placing them alternately.
• Fully extend the heating cable and insert it into the suction cup clips like a coil.
• To better control the temperature, it is advisable to connect Aquacalor to a thermostat.

SAFETY RULES

• All electrical equipment used must be connected to an automatic differential switch with a 30 mA threshold.
• Check that the voltage printed on the cable corresponds to that of your electrical supply line.
• This product should be used exclusively inside the aquarium with a water temperature that does not exceed 35°C.
• Do not use the cable with corrosive liquids.
• Before connecting the equipment to the power line, check that neither the product nor the cable are damaged in any way.
• The power cord should not be replaced or repaired. If damaged, replace the entire unit.
• Do not use the equipment for purposes other than those indicated.
• Unplug the power cord before moving the device. If the connection plug or power outlet is wet, turn off the main switch before unplugging the equipment.
• Keep the equipment out of the reach of children.

Download information Aquacalor Prodac (PDF)

www.prodacinternational.it